|
Tractor Talk Discussion Board |
Re: Plastic gas containers - any clever way to ven
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Nick Rettler on December 21, 2006 at 03:20:02 from (209.103.198.134):
In Reply to: Plastic gas containers - any clever way to vent ? posted by IHC Red on December 20, 2006 at 10:45:31:
I install a metal valve core adaptor for a steel rim opposite of the spout. Removed the valve core and covered it with a metal screw valve cap. The rubber seal did not last to long. Had to change it out with neoprene. Installed with a wire from the filler port. Works GREAT and does not leak if the can tips while transporting.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
The Great Escape - by Dave Hollrah. It all began Monday with a little baling of second crop on the lake shore field, and as I drove out past my sister and her hubby's place, this small calling sound could be heard from the general direction of their manure pile. Out of the yard, over the cows and bale piles, through the dozer piles, poplars, and brush, out onto the ditch grade road, past the noisy 6.2 diesel engine pulling my well traveled Suburban along. Well it sure didn't take me long to figure out what it was because I alrea
... [Read Article]
Latest Ad:
L35 Kubota
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
