stud valve lever assembly famall c 1948

Posted by Mickey Arnold on December 20, 2006 at 15:32:37 from (68.59.243.18):

I am re-assembling the engine on a 1948 Farmall C. It was dis-assembled when I bought it. I am missing one stud that goes from the head up thru the valve lever shaft end bracket. The stud has threads on both ends. The end that goes in the head is a coarser thread than the other end. The part number for the stud is 45 574 D. The valve lever end bracket is part # 42 099 DA.

I was also missing the nut that goes on the valve lever center bracket. A replacement nut fits the short stud at the valve lever center bracket, and also fits the original stud that is for the valve lever shaft end bracket.

Here's my problem. The replacement bolts I was going to use for the valve lever shaft end bracket don't screw into the head. I was going to use bolts of the correct length until I could get replacement studs for the original one I'm missing.

I'm wondering if the head is tapped to an odd size for these studs. Can anybody help?

Replies:

• Re: stud valve lever assembly famall c 1948 Bob 16:17:39 12/20/06 (0)

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]