Tractor Talk Discussion Board |
Re: Slipping away
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by coflyboy on December 18, 2006 at 09:53:30 from (4.226.255.58):
In Reply to: Slipping away posted by Kestrel on December 17, 2006 at 17:45:59:
Throughout my career the toughest lesson I had to learn was the difference between what I wanted and what I needed. In the beginning I did what I wanted to do with no thought to what was needed in the market in which I was involved. I got a lot of hard knocks. Finally I learn to look for a market, or niche, that was not being supplied or was not being supplied well. I finally reallized some rewards getting into these markets. It was not always what I wanted to do, but more often what needed to be done. I guess that I finally learned that since I was not the brightest bulb on the string I had to find a string without too many bright bulbs. Progress brings opportunity. This is the land of opportunity.
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|