|
Tractor Talk Discussion Board |
Re: 3-rib or 4-rib front tires?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Don-Wi on December 18, 2006 at 09:01:37 from (152.163.100.74):
In Reply to: 3-rib or 4-rib front tires? posted by Brian in MO on December 18, 2006 at 07:09:11:
A lot depends on the size too. Atleast around here... Some sizes the 3 rib is the only one available w/out special order, and some sizes only come in 4 rib w/out special order anymore. We always thought the 4 ribs grabbed a little better, but then again the 4 ribs were ussually a little fresher than the worn out 3-ribs. When they're bald, niether one will grip... I could do an experiment on our 1855 if I was feeling really motivated to swap tires around... We've got 3 tri-rib and 2 quad-ribs all on the same rims from our 1855, 1755, and a spair I picked up when I traded a smaller 7.50-16 w/ another guy on this board. I just did out a pair of the tri-ribs on our 285 though because the quad-rib 10.00-16's were bald and the 1755 was dead on 2 good fronts. Sorry, got rambling again... Any way. I could put the pair of quads on the 1855 in the spring, do some feildwork, then I could go back the the tri's and see if there is any difference. Trouble is, it's alomst impossible to find a 3-rib 11L-15 anymore (if one would go kablewy) w/out special ordering it, same thing with most front tires. Some are just easier to come by. Right now the 1855 has one of each.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|