Tractor Talk Discussion Board |
newbie with a Farmall A. Where to start.
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Craig A on December 14, 2006 at 19:41:53 from (67.142.130.49):
Hello all. I just purchased a Farmall A sn 169614 yesterday. She starts and runs clean, but I was told she needs a clutch. I don't want to ask lots of how to questions. What I could use is advice on what manuals, OEM or aftermarket, you have found to be best for doing service. Also do you have favorite sources for the small parts? I figure while broken, replace the rear oil seal, oilpan gasket, and take a look under the valve cover. Do you have any suggestions on who can supply those seals? Thank you for any suggestions. Craig
Replies:
Home
| Forums
Today's Featured Article -
Talk of the Town: How to Crank Start a Tractor - by Staff. This interestin discussion is from the Tractor Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|