|
Tractor Talk Discussion Board |
Re: barley for beef
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by pafreehling on December 12, 2006 at 20:31:18 from (167.239.209.46):
In Reply to: Re: barley for beef posted by JMS/MN on December 12, 2006 at 20:15:39:
I knew the feed conversion barley to corn is close on a feed value scale and the information you sent confirms it. I am always looking for options or just trying new things so long as they do not create an irreversible scenerio you then are forced to suffer through for a whole year. The costs associated with raising corn:seed, chemicals, and of course fertilizer (N) are climbing and between oats(youngstock), silage and maybe barley for finish cattle I hope to hold costs down a little bit. Oats are cheap to raise and we get really good yields and I hope barley does OK on input cost to beef production balance sheet.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Machine Shops - by Curtis Von Fange. It is a story that repeats itself countless times. In the process of rebuilding a particular section of the tractor there is a broken part for which a replacement cannot be found. The parts houses find in their catalogue that it is unavailable. The dealerships call it a discontinued part. Salvage yards define it as hard to find or, even worse, rare. Everyone on the NET says, 'what is it?' But don�t despair there is another avenue that can be used to get that piece repaired. The local mach
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|