Re: Noise

Posted by dr.sportster on December 03, 2006 at 18:50:37 from (67.72.98.88):

In Reply to: Re: Noise posted by Hobobob74 on December 03, 2006 at 18:17:45:

If you dont know what oil is in it now you could start with an oil change using the recommended oil.Then monitor the oil pressure.As a rod bearing wears it will show some drop in pressure.You can sometimes go for a good while with a rod knocking but if it lets loose it can break the block or pan.It could also be the small end of a rod which is not as threatning.As an experiment you could also try a can of STP or Wynns [doesnt fix anything but may keep the noise down].One thing that does go away with warm up is piston slap which is also not realy going to cause damage.Hard to say without hearing it.Watch the oil pressure.

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]