|
Tractor Talk Discussion Board |
Re: Power Wagon wheel cylinders
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by charley hellickson on November 29, 2006 at 23:34:25 from (12.216.146.38):
In Reply to: Power Wagon wheel cylinders posted by Roy Suomi on November 27, 2006 at 15:06:50:
Hi Roy. Sorry I just found your post, I have been in the hospital for a few days. Stomach was hurting so bad I went to the ER Monday night and got home Wedsesday afternoon. ER Doctor said he had never seen anbodies belly with so much air in it. On those wheel cylinders, the large bore,cup, goes to the rear. I didn't know they were made with two sizes in one cylinder untill I looked it up. That is one Dodge I never worked on. Hope this helps. Good luck with it. Charley.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Recollections of a John Deere GP - by Charlie Cook. I grew up on my dad's 280 acre general farm in Western Michigan. Dad's only tractor when I was very young was the old GP. My first recollection of this tractor was when dad allowed my brother and myself to ride on the tractor with him driving. One of us would sit on the left fender (away from the clutch) and other would sit on the gas tank and hold onto the crankcase breather pipe.
... [Read Article]
Latest Ad:
1952John Deere MT tractor
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
