|
Tractor Talk Discussion Board |
Re: Removal of ratchet starter drive from starter
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Patrick NM on November 23, 2006 at 11:07:28 from (12.189.32.59):
In Reply to: Removal of ratchet starter drive from starter shaf posted by RFE on May 14, 2005 at 16:27:20:
I know I'm a little late but better late than never. What I did was I took a 1/4" drill bit and ground a slight angle on one side and stuck it in the hole on the drive and used it as a lever and pried the washer down and put a feeler gauge in the gap and I was able to push the pin in with my finger enough to get it started and than put the drive on the starter and tap through the hole. It sure saves the old arm pit.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Antique Tractors a Passing Fad? - by Tractor Talk Forum Participants. A Talk of the Town article - Do you see antique tractors going out like a fad? Value has come down this winter. An example is the Ford Model A and T cars that went through this in years ago, along with the hit & miss engine. Will the younger generation move on to something else? Will it be harder to sell them and what models will be affected? Could we see the value crash on our rusty relics?
... [Read Article]
Latest Ad:
Ford 3-Point Single Bottom Moldboard Plow with Coulter
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|