|
Tractor Talk Discussion Board |
Re: Water in oil
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Vern-MI on November 11, 2006 at 11:37:08 from (207.69.138.8):
In Reply to: Water in oil posted by 37 chief on November 11, 2006 at 10:41:21:
You have cavitation corrosion and it can be fixed by maintaining coolant at the correct pH level to prevent cavitation corrosion (rust) � the natural way in which metal converts back to its original ore form. Liner cavitation-erosion occurs along the thrust angle of the piston, especially in engines with wet liners. The liner sits inside the block and rings like a bell when the piston compresses and fires, causing intense pressure changes at the cylinder wall that result in liner cavitation. Liner cavitation, or pitting, is avoided by using an engine coolant with a nitrate component as it forms a monomolecular ultrathin oxide coating around the liner. The pH should be maintained at levels between 7 and 8.5 in engines with soft and harder metals. A pH of below seven is more acidic and aggressive to harder metals, like cast iron or steel, while a pH above 8.5 becomes more alkaline to soft metals such as aluminium, copper and brass. It is therefore important to incorporate a coolant with a pH buffer, such as borate, to regulate the pH in coolant at safe levels. Approved coolant manufacturers offer fully formulated coolants that afford wet liner protection without the need to add extra additives. Coolant dilution is an absolute must. If coolant concentrations was changed to 70% coolant and 30% water, the heat-transfer value would go up while corrosion protection will drop drastically.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Show Coverage: Argyle and Mt. Pleasant Labor Day Weekend Shows - by Cindy Ladage. The last fling before summer fades into fall and we get busy in the fields are the annual Labor Day tractor shows. Beginning on September 5th and running through the 7th, the Argyle Antique Gas and Engine Show is held at the Argyle State Park. Located in West Central Illinois, the pine forest was the setting for the opening of the 22nd show. This year we decided to try to sell a few tractor parts, literature and wrenches to offset my husband's buying sprees. Saturday
... [Read Article]
Latest Ad:
65 massey ferguson diesel
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|