|
Tractor Talk Discussion Board |
Re: PTO to Belt drive
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by steveormary on November 06, 2006 at 17:23:45 from (216.31.92.17):
In Reply to: PTO to Belt drive posted by Bill Okrasinski on November 06, 2006 at 12:59:41:
Bill If you have the belt pully for a Ford or Ferguson with the 11/8th pto shaft you shouldnt need an adapter. The pully should bolt right up after you take the sway chains off. Also,bolt the pully so you have to give the belt a twist to run the blade in the right direction. We bolted ours so the pully was on the right side looking toward the back of the tractor. steveormary
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Maintaining Rubber Tires - by Staff. The broad use of rubber tires on farm tractors and machinery has resulted in a great saving in both time and operating costs since the time of steel wheels. There are, however, certain basic fundamentals in the care of tires that should be followed carefully if the owner is to derive maximum benefit from his or her investment. First and most important is to maintain proper pressure for the work at hand. Your best guide to proper inflation is the operator's manual or instruction book tha
... [Read Article]
Latest Ad:
2555 Mahindra Shuttle 4x4 heat,air,diesel,7ft Mahindra heavy duty bushhog 7ft snowblade bucket
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
