Re: What to do next?

Posted by Janicholson on November 06, 2006 at 07:15:41 from (199.17.6.122):

In Reply to: What to do next? posted by Jrry on November 06, 2006 at 06:57:53:

Disconnect the (small) wire from the coil to the distributor. Using two jumpers with clips on their ends, take a ignition condenser and attach one jumper from its body mounting tab to ground. Take the other jumper and go from the coil empty terminal (from above disconnect) to the lead on the condenser. Pull the spark coil wire out of the distributor, and tape it so it is 1/4" away from the engine block. Turn on the ignition and (holding the body of the condenser)touch the condenser lead to a clean shiny ground. A tiny spark may happen at the point in time when you touch it, but when you pull it away the spark at the coil wire should jump fat and blue to the block. If this works, you have either a bad electronic unit, or it is not wired correctly, or it is for the wrong polarity of battery ground in your unit. Good luck, JimN

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]