|
Tractor Talk Discussion Board |
OT: A different front end for Kubota 3710
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Matt H NY on October 23, 2006 at 14:54:41 from (66.24.240.89):
Hello all I have a Kubota 3710 that has about 6800 hours on it. The problem that I have is the 4wd front end is completly worn out. The cost of a new or rebuild unit is too much as the tractor scrapes the freestall twice a day and 4wd is not needed. We just need a 2wd axle to put under it so it can get the job done. Scraping with the skidsteer is too much wear and tear. I dont want to spend a lot of money on this project as the tractor, even though its only a few years old, is not worth a lot. The motor runs like a top and rearend is tight and sound (the cheap sheetmetal is all rotted off though)lol. Cow manure is corossive stuff. So if anyone knows of a 2wd front axle that will fit i will appreciate the suggestions. It can be kubota or any other brand for all i care. I just need a cheap retrofit so i can put the tractor back in service.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
