Tractor Talk Discussion Board |
Re: How big a machine shed?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by jmixigo on October 17, 2006 at 11:26:56 from (69.73.54.156):
In Reply to: How big a machine shed? posted by Dan-IA on October 17, 2006 at 11:01:59:
You usually end up with less waste if yore measurments are divisible by 4. Like 28 or 32 wide. You can't make it too big cause if its the same size as the Astro Dome you'll fill it up anyways. And I try to make clearance 14 foot, so you can clear a 13'6" semi if you ever need to even if you gravel the floor later on. If you gone use prefabbed trusses ALL WAYS have em on site before you set the second wall. His measurements and yore measuring is all well an good, but if some body screws up then life is easier when a minor adjustment can take care of things. BTDT
Replies:
Home
| Forums
Today's Featured Article -
Restoration Story: 1951 Farmall H - by The Red (John Fritz). I have been a collector of Farmall tractors since 1990 when I first obtained part of the family farm in Eastern Indiana. My current collection includes a 1938 F20, 1945 H, 1946 H, and the recently purchased 1951 H. This article will focus on what I encountered and what I did to bring the 1951 NEAR DEATH Farmall H back to life.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|