|
Tractor Talk Discussion Board |
Re: Width of Tractor
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by dej(JED) on October 04, 2006 at 05:27:34 from (66.212.151.134):
In Reply to: Width of Tractor posted by oldfarmtractor on October 03, 2006 at 09:23:19:
I haul an M and other tractors on an 84" wide , between the fenders trailer. Even if you push the wheels in all the way, an M won't fit. You have to turn at least one wheel. With an H you need the wheels in. The trailer gross weight is 7000lbs and the axels are 3000 each, with brakes on both. I pull the whole deal with a 1500 GMC 4 wheel drive with a 327 gasoline engine. It hauls well and stops easily. For wide wheel bases we use 2, 10"w x 6"h x 6'l, wood blocks. We run teh tractor up on them and then chain it down. This way we can haul wider tractors.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Step by Step Carburetor Overhaul - 1952 Ford 8N - by Don Stewart. The carburetor kit for the TSX-241A/B/C carburetor is being supplied in only one flavor nowadays. It includes a replacement throttle shaft, new butterfly valve screws, fuel inlet filter, new float needle and seat, new float pin and
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|