|
Tractor Talk Discussion Board |
Re: Clearing brush. I might have OCD.
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Fluggie in IA on September 29, 2006 at 07:03:42 from (216.51.138.241):
In Reply to: Clearing brush. I might have OCD. posted by Slofr8 on September 29, 2006 at 05:55:17:
Don't know where you're at, Slofr8, but, if your north far enough to where the ground freezes in winter, hire a dozer right after the ground gets hard to about 1 foot and he can "shave" the trees off at ground level leaving you with a nice mowable area and a non-dirt filled pile of brush. Done this a few times and sure is a lot neater than doing the cleaning in the summer. If you need the stumps out, then do the disc method later like Bill says. works here in north Iowa!
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
History of the Nuffield Tractor: Conclusion - by Anthony West. In the last piece I mentioned that Nuffield had reached the stage where they had chosen to drop the "Universal" from production. The two new models were given three figure numbers, instead of "three" and "four". Model numbers were introduced to help farmers and dealers instantly recognize the engine size and horsepower of the tractor, the 4/60 had a four cylinder diesel engine which developed 60 bhp at 2,000 rpm. The 3/42 had a 3 cylinder diesel engine which produced 42 bhp at 2,000 rpm. Th
... [Read Article]
Latest Ad:
1952John Deere MT tractor
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|