Tractor Talk Discussion Board |
Re: John deere 14T baler help needed
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Kelly Campbell on September 22, 2006 at 13:46:04 from (168.111.103.212):
In Reply to: John deere 14T baler help needed posted by chubbygumby on September 22, 2006 at 13:05:08:
Check the knotter trip arm assembly, it may be loose or your break might be miss adjusted...if possible get someone to drive while you walk behind and watch to see whats going on...I don't know about JD equip, but on Masseys there is a roller where the trip arm rides, and of course there is an adjustment for this as well...It might be the case that your knotter trip arm may not be falling back down all the way...I had this problem earlier this year and it cost me two billhooks, knives, gears etc....basically new knotters......:( Good luck, I'm sure more will chime in here
Replies:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|