|
Tractor Talk Discussion Board |
stuck clutch/ Ford 9000
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Gunsmoke on September 18, 2006 at 12:47:25 from (64.186.36.66):
I purchased a Ford 9000 with dual power that had been parked in working order and left to sit for 7 years. The parking break was stuck, engine was lightly stuck both of which I now have working well.
In netral the tractor starts and runs but after depressing the clutch the gears are still spining. I have started it in gear and it will drive in that gear but the clutch will not dissengage. The peddal has good tension and I adjusted all the travial out to apply the most preturn force possiable.
I have run it for several miles to get it heated up and pushed in the clutch the whole time along with hitting the breaks repeditly, still engaged. I then hooked to a field cultivator and set it deep pulling the engine hard with the clutch peddal depressed most of the time. 2 hours later and I have a worked up field but the clutch is still engaged. There are no inspection covers on this tractor and spliting it would be to big a task yet this fall. Dose any one have any sugestions on what you have done for this situation? Also what is your opinion of the 9000, what are its problem areas?
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Bad Vibes - by Curtis Von Fange. One of the strangest ways to communicate with our tractor is to ask it how it feels. "Ask it how it feels," you say? Yup, ask it how it feels. Now, as with the other articles in this series one has to be able to hear what 'ole blue' is trying to say in response. The nice thing about our old iron friends is that they are usually quite consistent in their response, rather unlike some people I know who might change what they say due to the weather or other mitigating circumstances. But since t
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
