|
Tractor Talk Discussion Board |
Re: o/t Ford 460 big block specs
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by B-maniac on September 17, 2006 at 11:59:20 from (207.241.134.249):
In Reply to: Re: o/t Ford 460 big block specs posted by Bob on September 17, 2006 at 00:15:01:
All you are getting is cubic inches. These engines have no power as built. The older ones built in the late '60s (429/460) had good iron in them,also some had 4 bolt main caps,some forged cranks and rods.They also had high compression and some pretty good heads. All you are getting here is a block with 460 cubic inches.You will have to buy your horsepower cause as it stands now it is nothing but dead weight and has nothing to offer you for pulling.You will be very dissapointed.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
