|
Tractor Talk Discussion Board |
Re: Diesel Engine Issue
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Bob on September 07, 2006 at 09:13:09 from (66.163.134.211):
In Reply to: Re: Diesel Engine Issue posted by Tramway guy on September 07, 2006 at 09:06:34:
That's what I suspected. Sounds like the plastic governor damper ring deep inside the pump has become brittle, and distintegrated, and pieces of it are jammed in the housing pressure regulator valve/return fitting that screws into the punp cover. (This, or any other obstruction in the fuel return circuit will cause the engine to shutdown, as his is doing.) Removing the fitting/valve and cleaning it out SHOULD allow it to start and run, but get the pump OH'd because as the plastic ring completely fails, the metal parts it isolates will bang together, causing wear and metal filings in the pump.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
It Can't Be Done! - A Tractor Story - by Neil Campbell. I'll never forget the time back when I was a boy baling hay on our Farm in Big Rapid, Michigan. The most memorable event that took place was a trip up the steepest incline on the farm pulling an old New-Idea baler with a pony-motor for power and a haywagon. I had just talked my Dad into buying an old John Deere B with 6-speeds ahead and I was real proud of it, except it was a little smaller than the Case tractor that we normally
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|