|
Tractor Talk Discussion Board |
Fit, Work, Or Bolt Up??
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Dick L on September 05, 2006 at 12:48:24 from (74.39.22.251):
In Reply to: Oliver 60 front rim size posted by Kurt Smith on September 05, 2006 at 10:03:54:
Brad is as bad as I am. I have 7 Oliver 77"s only two of them have the cast front hub, five have the stamped steel rims. The bolt pattern should be the same but the 66, 77, and 88 had 16 inch rims and the 60 has 15 inch rims. I have a 60 and a 66 sitting side by side and checked with a tape measure as close as I could and the bolt pattern seems the same.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
It's Alright Where It Is! - by Anthony West. I have a tale of a different kind to tell. Whilst rooting in the hedge bottoms this week I had cause to visit Chapel lane Farm, the home of an eccentric gentleman by the name of Austin Kendall. I had heard rumours that an old Case Model C was languishing away in the back of one of the outbuildings there. So off I went in search of what would turn out to be a very rare and unusual tractor. Mr Kendall is an excitable chap to say the least. He is amongst the last of a dying breed of farmer who
... [Read Article]
Latest Ad:
Wanted to buy model 65 massey ferguson 65 diesel
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
