|
Tractor Talk Discussion Board |
Re: overheating?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by buickanddeere on September 03, 2006 at 13:00:16 from (209.240.120.42):
In Reply to: overheating? posted by oj on September 03, 2006 at 09:46:03:
200-220F from the engine outlet into the rad is fine. The engine doesn't even clean up and burn fuel proper until on the high side of 195F. Just keep a decent rad cap on it and make certain the corrosion inhibiter is active. Everybody checks for the freezing temp but forget about corrosion until hole sar epitte dthrough the sleeves. Use distilled or demin water to mix and fill the cooling system. Anything out of a well or ditch contains minerals that will plate out onto the heat exchanging surfaces. The only engine that needs to run 160F to 180F is a turbocharged/supercharged gasoline race engine.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
On the Road with Dave Gohl: Auction Musings - by Dave Gohl. I was thinking the other day about all the auctions I've been to in the last few years. There've been many. Some have been very good, some have been well, disappointing to say the least. But no matter how good or bad auctions may be, we always seem to stay until the item we've come for or are interested in is on the block. I've been to some auctions near and far. I think the furthest has been the Two Cylinder 7 in the Amana Colonies last year. Lots of stuff, lots of people. I've also atten
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|