Tractor Talk Discussion Board |
Re: OT what paint will hold up on utility trailer
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by B-maniac on August 27, 2006 at 18:57:55 from (207.241.134.56):
In Reply to: Re: OT what paint will hold up on utility trailer posted by CNKS on August 27, 2006 at 12:55:39:
I agree 100% with CNKS. There is NO coating that is going to hold up to the stone blasting. We build brush chippers where I work,and we went to using aluminum diamond tread fenders for this very reason.These machines are hauled behind dual wheeled trucks for the most part, I suggest getting some of this in sheets and cutting it to size to cover the blasted areas.Yea, it won't stay shiny,but won't rust and looks better than chips.
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|