|
Tractor Talk Discussion Board |
Re: OT - will hemlock lumber hold paint?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by jdemaris on August 27, 2006 at 18:50:59 from (66.218.23.39):
In Reply to: OT - will hemlock lumber hold paint? posted by Tim in New York on August 27, 2006 at 09:09:58:
It will hold paint fine if you can ever get it dry. That's not easy in New York State. I had some 14" wide hemlock boards planed on one side and kiln dried a few years ago - to make some barn doors and the oil-base paint I used worked with no problems. If you're using a light paint though, use a good primer because the tanin in the hemlock bleeds through.
If you ever buy any ornamental pressure-treated wood, like porch turned spindles or post-caps, they are usually Canadian Hemlock (instead of Southern Yellow Pine). The Canadian hemlock seems better quality than our New York hemlock.
I've also noticed that hemlock does not hold a flat surface after drying and planing - the grain keeps coming up.
In regard to green hemlock, I've got two newer barns sided with it (board and batton), and one old barn built around 1830 (lapped horizontal siding). The addition on my house is also hemlock - vertical channel shiplap, 12" wide boards. The hemlock siding has never seemed to get dry enough on any of them where I'd want to risk painting. I prefer it bare anyway because it weathers to a nice orange-brown color - unlike White Pine that seems to weather to dull ugly gray.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Fasteners: The Nuts and Bolts of Nuts and Bolts - by Curtis Von Fange. The nuts and bolts of nuts and bolts is an interesting and essential piece of knowledge that applies to our older tractors. An improperly torqued capscrew on an engine head or a shear bolt that is too hard on the driving shaft of a bushog can create havoc and make an expensive and uncalled for repair. Let�s examine the purpose and design of these fasteners in order to ensure their proper use. Fasteners are probably one of the aspects of mechanics that is given the least amount of thought.
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
