|
Tractor Talk Discussion Board |
Re: Starter Drive Problems
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by noncompos on August 25, 2006 at 22:08:48 from (65.102.43.41):
In Reply to: Re: Starter Drive Problems posted by Miss Kelly on August 25, 2006 at 10:21:32:
When you hit the starter button it just spins, doesn't engage the engine flywheel ring gear: that's usually a bad starter drive or a bent starter shaft that won't let the starter drive gear slip down the shaft, into the flywheel ring gear, to turn the engine...but it does sometimes slip down the starter shaft to engage the engine flywheel or it couldn't get stuck in the flywheeel ring gear, which could be a bad starter (not enough energy to turn engine when it does engage) a bad drive (binding or locking up when load of trying to turn engine hits it) or damaged teeth on the flywheel ring gear locking into the starter drive gear, preventing it from turning the engine. UNLESS when the starter just spins it makes a grinding noise (starter drive gear throwing into engine, but not enough teeth left on engine ring gear to turn engine, gears grinding until they lock.). Question: on the starter drives you've replaced, was the little gear on the end of the starter drive worn or damaged? After only a dozen or so starts, it should look just like new on a normal rig; if your ring gear teeth are bad, there should at least be scoring on the starter gear. My experience sez bad ring gear teeth, but the "just spins, doesn't engage" bothers me, unless it's screechy noisy. The suggestion about turning the engine was right; on old cars we'd jump out,IGNITION OFF,raise the hood, grab the fan belt with one hand, enough to pull it tight, and the fan (near the hub) with the other, turning the engine a little by pulling (carefully!) on the fan, turning the bad spot away from the starter.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Memories of a Farmall C - by Monty Bradley. When I was a child, my grandparents lived on a farm owned by a Mr. Walters. The crops raised were cotton and soybeans, with about forty head of mixed breed cattle. Mr. Walters owned two tractors then. A Farmall 300 on gasoline and a Farmall C, that had once belonged to his father-in-law, and had been converted from gasoline to LP Gas. Many times, as a small boy, I would cross the fence behind the house my grandparents lived in and walk down the turn row to where granddaddy would be cultivati
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|