|
Tractor Talk Discussion Board |
1947 WC Allis Chalmers - low oil pressure
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Chuck and Mike on August 05, 2006 at 13:17:53 from (209.98.66.15):
We recently got our 1947 WC Allis Chalmers running after it had been in storage from '88 to '04. For the first 3 to 4 hours of running the oil pressure was always in the middle of the normal range (the gauge is new and only shows a normal range, not psi). A few days ago we drove it about 5 miles to the local county fair to run in a parade. About half way there the oil pressure started slowly dropping to the very bottom of the normal range. It was running fine, so we ran it in the parade and then drove it home (the oil pressure never got any higher). We started the tractor again this morning and the oil pressure was back in the normal range. The engine idled for about 15 minutes and the pressure dropped a little, but it was still in the normal range. We adjusted the idle screw and needle valve on the carburetor (they were set too rich). The oil filter is new (Agco brand), there is fresh 30w oil in the engine, new spark plugs (Autolite 295�s) and a rebuilt carb. The engine head had been removed and reinstalled (the engine rusted and the pistons got stuck while it was stored and the head was removed to 'un-freeze' it so it would start), but the gasket was not changed (it leaks). Also, the oil pan, push rod cover plate, and front crank shaft seals leak. Any ideas on why the oil pressure the pressure would suddenly drop so low like this? On shorter trips, the oil pressure never dropped significantly. The engine was rebuilt back in '81 (not sure what work was done on the camshaft and bearings) and only has about 25 hours on it. At initial cold start-up, there is some blue smoke out of the exhaust, but it eventually goes away, but while the engine is running, there is a slight smell of oil burning. We have not adjusted the pressure relief valve yet. Could the fact that the carburetor was set too rich have anything to do with this? Any ideas that any has on why the oil pressure would change like this would be greatly appreciated. Thank you.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|