|
Tractor Talk Discussion Board |
Re: will a house 5ft brush hog tear up my ford 8n
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by DickTN on August 02, 2006 at 04:12:17 from (68.84.93.85):
In Reply to: will a house 5ft brush hog tear up my ford 8n ? posted by Jody Nalty on August 02, 2006 at 03:53:51:
The Howse 5 foot bush hog should work very well with your N. A couple of things you WILL need are an overrunning coupler and limiter chains. The ORC is needed because the N tractors drive the PTO in such a fashion that the inertia from the bush hog spinning will drive the tractor into anything in front of it if you don't use an ORC. The limiter chains control the cutting height so that you do not have to depend on the hydraulics to maintain proper cutting height. One thing to check is whether you have the original 1-1/8" PTO shaft. If so, it might be worthwhile to install the updated 1-3/8" shaft to gain the added shaft strength. HTH
Replies:
Home
| Forums
Today's Featured Article -
The David Brown Rose Badge - by Samuel Kennedy. In the 13th century civil war was raging in England. Two English noblemen were involved in a conflict which became known as the War of the Roses. The Duke of York had as his emblem a white rose and the Earl of Lancaster had a red rose. Today the white rose is the official emblem of the county of Yorkshire and the red rose has been adopted by the neighboring county of Lancashire.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
