Tractor Talk Discussion Board |
Re: will a house 5ft brush hog tear up my ford 8n
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by DickTN on August 02, 2006 at 15:56:24 from (68.84.93.85):
In Reply to: Re: will a house 5ft brush hog tear up my ford 8n posted by Jody Nalty on August 02, 2006 at 05:17:02:
Jody, the bearing and seal can be changed on the PTO shaft. However, it will take at least a 10 ton press to get the bearing off. Your call, of course, but unless funding is a problem, I'd elect for the 1-3/8 shaft which will come with the new bearing and seal already installed. Of course, this will require a different ORC if you have the original 1-1/8" shaft installed now. Procedure for changing the shaft is simple. Nose the tractor down into a ditch (avoids losing hyraulic fluid), remove the four bolts holding the PTO assembly in, take the old shaft out and stick the new one in. Job done. HTH
Replies:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|