|
Tractor Talk Discussion Board |
Re: O/T help with wifes caravan
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by KEB on August 01, 2006 at 20:27:37 from (207.94.27.4):
In Reply to: O/T help with wifes caravan posted by perry in mi on August 01, 2006 at 16:55:05:
Best bet is a problem with fuel pressure, either a weak pump or a bad pressure regulator. When you start the engine, it injects a pre-determined amount of fuel based on holding the injector open for a pre-determined time. If the pressure is a little low, it won't inject enough fuel, but if you give it a little extra it'll start right up. Once the engine is running, it'll automatically adjust the injector cycle to run at the proper speed and mixture, thereby compensating for the reduced flow rate through the injector. When you first turn on the key, you should hear the fuel pump run until it builds a pre-determined pressure or runs for a pre-determined time (not sure which Chrysler uses). If you cycle the key too soon, it won't run again. There should be a valve or connection on the fuel rail where you can attach a guage to measure fuel pressure. If not, you may have to tee into the supply side (not the return side). There should be a specification for fuel pressure prior to starting. I had a Chevy with a similar problem once, and the fuel pressure was only 5 - 10 lbs low. Turned out to be the fuel pump itself, lots of fun dropping the tank to replace it. Carried a small bottle of gas to prime it with for a while until found a guage & figured out what was going on. Good luck, Keith PS...don't know about Chrysler, but Chevy's have a shrader valve on the fuel rail which is the same size as the shrader valve on an automotive air conditioner (don't remember if its the R-12 or R-134 size, but the meter came with an adapter). A $10 air conditioner pressure guage from a chain auto parts store worked just fine as a diagnostic tool. Before someone sqwacks, I'd never use it on an air conditioner once it had gas in it...
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Seeing an Old Friend - by Joe Evans. Dad had a concrete contracting business starting in 1960. One of his first pieces of equipment was a Ferguson TO-35 with a Davis loader. Dad replaced the TO-35 with a MF 202 Workbull, essentially an industrialized Ferguson 35 I am told. Dad bought the 202 new in 1962, and I recall quite clearly going to the dealer with him to sign for it.
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|