Tractor Talk Discussion Board |
Re: Seeking Trailer Building Advice
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Luke S on July 24, 2006 at 10:46:33 from (65.161.251.246):
In Reply to: Seeking Trailer Building Advice posted by Buzzman72 on July 24, 2006 at 08:32:31:
As others have said, your deck size will acomadate a lot more than the trailer can handle. Frame is probably not strong enough, and axle's/wheels/tires probably aren't either. Now, if this rig is going to stay on the farm and not go down the road, it just might work. But I would darn sure not want to go down the highway with that thing loaded with hay. I'll be the frist to admit that I haul loads that are way to big and a lot of people think I am crazy, but I run a 48' flatbed trailer that weighs 8,000lbs by itself, so it has got some steel in it and I don't have to worry about it buckling under the load as you may have to with this rig you are talking about.
Replies:
Home
| Forums
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|