Tractor Talk Discussion Board |
Re: O/T cement question. Made for the old timers
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Glenn F. on July 23, 2006 at 04:12:05 from (64.109.36.103):
In Reply to: O/T cement question. Made for the old timers posted by old on July 22, 2006 at 21:27:15:
Years ago we were building a new silo house. We had some leftover concrete so we quickly formed up an apron by the overhead door. Us four boys hustled and found all the rocks we could. It was amazing how big of an apron we were able to come up with with so little concrete. We couldn't do it again though as that farm simply did not have any rocks. The ones we found were hauled in the yard at different times for some other purpose. Even though the apron was formed up quickly, and didn''t have a proper sand base, years later, it still didn't have a single crack. Glenn F.
Replies:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|