Tractor Talk Discussion Board |
Re: Nasty, Nasy, Nasty Job!
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Allan In NE on July 19, 2006 at 07:15:15 from (148.78.243.25):
In Reply to: Re: Nasty, Nasy, Nasty Job! posted by MidMiGene on July 19, 2006 at 06:46:00:
Hi Gene, They are right behind the raddle cleanout door at the otter edges and "just inside" the housing. They are the bearings that the lower end of the chain rides on and they incorporate the chain tightener on the outside of the feeder housing. They are a real bear to get at. Have to lock the header in the up position, pull the cleanout door and "squeeze" yourself up into that small little space behind the concave door, with no light, to work on the darned things. It is far easier to unhook the chain to get 'em out of there, but they will come out with the chain in place if you hold your mouth just right. The only difficult bearing to get at on a Gleaner. I'm used to running the machine in dry edible beans, which translates into running a heck of a lot of dirt thru the combine and these bearings have to be checked yearly under these conditions. Allan
Replies:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
John Deere B 1943
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|