Tractor Talk Discussion Board |
What engine would you like to see made?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by NC Wayne on July 03, 2006 at 22:05:11 from (64.12.116.74):
Hey guys, I just read an article about this outfit and checked out their website. They take full sized engines and reverse engineer them down to a 1/4 scale. The final product is a running engine. I reas the article in the print magazine but I believe you can read the same article online at--- machinedesign.com---- It tells what all they put into downsizing and making these jewels. If you can't read the article great, if not you can still check out their site where you can see the finished products. I don't see any pricing anywhere but judging by what the article was saying their "quite proud" of them and I can understand why. Supposidly their next offering is gonna be a V12 Rolls-Royce Merlin engine like ran in the P51 Mustangs. This leads to my question. If you had your choice what engine would you like to see them to make?? First choice, for me would be a two cylinder Deere engine. Second and third choice in no particular order would be either a Detroit or a Murphy. I know the last two are diesels and they'd have to put an ignition system on them because the models run on methanol, but it'd still be neat to see even if it wasn't 100% "authentic".
Replies:
Home
| Forums
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|