Tractor Talk Discussion Board |
Re: Hydraulic shaft is scratched
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Allan In NE on June 21, 2006 at 20:17:44 from (148.78.243.24):
In Reply to: Hydraulic shaft is scratched posted by Dug on June 21, 2006 at 19:11:55:
Boy, I dunno Dug, Guess I disagree with everybody. Takes one heck of a scratch to leak. Now, gouges will run oil out on ya a little. I overhauled a cylinder this morning that was bent down and to the left like an old man. While I had it apart, I put the goffy thing in the hydraulic press and bent it every which way until I got the ram reasonably straight. Point being, I left jack dings, flat spots and "tracks" all over that silly ram. Hooked 'er up and it doesn't seep a drop. Is yours so bad that it actually leaks? Or, are ya putting the seals in backwards? They can only go one direction. Allan
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|