Tractor Talk Discussion Board |
Re: OT-Dodge Auto Transmissions
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Joe(TX) on June 19, 2006 at 15:14:17 from (216.148.248.75):
In Reply to: OT-Dodge Auto Transmissions posted by ld5030 on June 19, 2006 at 06:44:04:
Whoever told you Dodge transmissions are not that great has never had one or was someone mentioned on one of the other posts. A lot of problems stem from buying a truck that is too light and geared wrong for what they get used for. I have a 92 Dodge diesel with 240,000 miles on it. I personally put over 130,000 mile on it and have had no problems with the automatic transmission. I do pull loads on the trailer of 6500 pounds or more quite often. I have hauled my 12,000 lb tractor although I don"t recomend doing it.
Replies:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|