Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 
Marketplace
Classified Ads
Photo Ads
Tractor Parts
Salvage

Community
Discussion Forums
Project Journals
Your Stories
Events Calendar
Hauling Schedule

Galleries
Tractor Photos
Implement Photos
Vintage Photos
Help Identify
Parts & Pieces
Stuck & Troubled
Vintage Ads
Community Album
Photo Ad Archives

Research & Info
Articles
Tractor Registry
Tip of the Day
Safety Cartoons
Tractor Values
Serial Numbers
Tune-Up Guide
Paint Codes
List Prices
Production Nbrs
Tune-Up Specs
Torque Values
3-Point Specs
Glossary

Miscellaneous
Tractor Games
Just For Kids
Virtual Show
Museum Guide
Memorial Page
Feedback Form

Yesterday's Tractors Facebook Page

  
Tractor Talk Discussion Board

Re: A little O-T but has to do with the farm


[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]

Posted by Hal/WA on June 16, 2006 at 17:06:59 from (66.45.175.118):

In Reply to: A little O-T but has to do with the farm posted by old on June 16, 2006 at 10:55:34:

Sorry to hear about your hay barn. I suppose there is no time now to replace it, what with haying season and other spring/summer chores.

Growing up, I lived on a small ranch. We had a pretty good barn and I have stacked many thousands of the small square bales in it, clear to the rafters. A few exceptional hay years, we had too much to fit in the barn, and so had to stack the excess outside.

The way our feeder was set up, we ended up dragging bales down the feed bunk and opening them more or less where they would be fed. So our outside stack was always just outside the back door of the barn for convenience. We always fed the outside hay first, since it was the least protected from the weather. My Dad had a huge canvas tarp that we draped over the pyramided stack. The tarp was very heavy, especially when it was raining or there was snow on it. I was always glad when the outside stack was gone and I didn't have to fight that darn tarp anymore!

It was also a pain trying to tie the tarp down. We didn't have anything like bungee cords, but mostly used baling wire or rope that would fit through the grommets in the tarp. I remember one time the wind was real strong and hit the stack just right and pulled the whole tarp off and away over the field--what a pain in the rear to fix that mess!

Anyhow, I don't know where you live or how much precipitation you get, but it sounds like tarping your hay is your only good option this year. I like the idea of using pallets to keep the hay off the ground. I don't know how much of a problem it will make to move the large bales--I would worry about the pallets freezing down here and making it so you couldn't drive a tractor there.

I have found that the cheap, thin blue tarps work pretty well in the short term, especially if you run rope over top of them a few times, to prevent the tarp flapping in the wind. You still have to tie them down real well, though. If you get much snow where you are, I predict that you will get real tired of those tarps before the winter is over...

Hope you can get a new hay barn built. Good luck!


Replies:




Add a Reply

:
:
: :

:

:

:

: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and ... [Read Article]

Latest Ad: Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor [More Ads]

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy