|
Tractor Talk Discussion Board |
Re: OT - Sealing wood on trailer
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by souNdguy on May 30, 2006 at 12:03:28 from (12.64.186.191):
In Reply to: Re: OT - Sealing wood on trailer posted by Mark on May 30, 2006 at 11:46:34:
If you believe that.. I think you are crazy.. not me. The GC I work for has been involved in cleaning up contaminated land.. We've done a weight station and a train station in the last decade.. the train station BY FAR had the worst contamination. Only worse I' have ever seen was an underground tank at a fuel station ( benzene levels for quite a ways around the station were extremely elevated.. and benzene is not nice to living tissue.. ) And the worst is a tie between an old unlined landfill and an old paint production facility. The landfill started having bad water tests around the area.. everyhting from battery's to old refer equipment had been in there. It's bad enough that they are considering excavating and lining it.. not to mention everyone was hooked up to city water as soon as the reports started coming out. The paint facility? So bad they are not even digging it up for fear of causing further exposure. Can't use well water for miles around it... It looks like a wasteland in that remote area of where town used to be. (poloution) It's plain chemical science. Proclaiming it doesn't exist then bring up nazi germany doesn't change the physical facts one bit. Look at CFC's and PCB's chlorflourcarbons.. I'll eave it as an exercise to investigate how many ozone molecules are destroyed by a SINGLE cfc molecule... and poly chlorinated biphenols.. nice stuff there... as good for you as benzene... Makes chromated copper arsenate leaching issues on playgrounds look almost 'ok'... Soundguy
Replies:
Home
| Forums
Today's Featured Article -
Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
