Tractor Talk Discussion Board |
Re: 44 mag, small chicken house and coon
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Easyy on May 26, 2006 at 06:48:21 from (198.208.251.24):
In Reply to: 44 mag, small chicken house and coon posted by old on May 25, 2006 at 21:39:51:
Dude! What do you use for deer? A 105 mm cannon? I have knocked off a lot of coons, but I use a 22 pistol or 22 rifle. I just want to kill a couple of varmints, not tear the barn down!!! If I shot off a 44 mag in a small building, I might not want to tell anybody about it much! LOL! Take care, One of my former neighbors shot his F150 with a 12 gage, a coon was in his garbage. That shot cost him $800. He missed the coon.
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|