|
Tractor Talk Discussion Board |
Re: Tire quality, is there much difference?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by RodInNS on May 12, 2006 at 05:31:53 from (142.177.109.52):
In Reply to: Tire quality, is there much difference? posted by Kent in NB on May 12, 2006 at 04:34:46:
Hi Kent, I've had a few sets of Galaxy/Primex tires. They're cheap, and they tend to wear rather quickly on hard surfaces.... but they are a good tire. Good casings, and probably the best value cheap tire out there. Firestones have always been good to me, give little trouble, and wear pretty good. GoodYears have good casings, and poor lugs. They wear bad, pull poorly, and shake your tractor to pieces on hard surfaces. Long bar/ short bar tires are a devil for that. Titan power grips will pull really well for a long bar/short bar tire, but as far as I'm concerned, they are just one rotten cheap tire. I've had blowouts with them, and with the old Armstrongs (Titan used to be Armstrong), and the casings are just plain poor on both. I will never buy a set. General is another that I would steer clear of. If you were looking for a value brand radial,then I would look at BFG. They are made by Michelin, look like an AgriBib, but are somewhat cheaper. If you're going to wear the tire out before it rots out, look at the radial because you get a lot more lug, and a lot more life, so in the end, the extra cost turns into a saving. I don't know anything about the Continental tire you mentioned, other than I had a few small impliment tires from them that were probably on par with the other makes in that size. That's not saying much, as I can't get one that lasts more than a few years.... Anyhow, good luck on the purchase. Rod
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
History of the Field Marshall Tractor - by Anthony West. Any restorer who has some knowledge of turn of the century farm machinery, will recognize the name Lanz Bulldog!! This machine was to say the least unusual in its appearance. The huge flywheel and coffee percolator shaped exhaust. Along with square body lines and cylinder head protruding forward of the front axle. Would become the visual differentiation that people would quote to separate the Lanz from other period machines. The Marshall company based at the Briannia Works in Gainsborough
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|