|
Tractor Talk Discussion Board |
Re: 9n 3 point
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by mn.Chuck on May 10, 2006 at 16:56:13 from (67.72.98.82):
In Reply to: 9n 3 point posted by stan frank on May 10, 2006 at 12:11:02:
Control Valve is stuck. If you take a round side
cover off(drain some oil down or tilt tractor to
the opposite side of cover removed)you will see
the two arms coming down from the top cover. They
cradle the valve that is not moving. A clip pin on
ea arm holds them to the moveable valve. Remove
them and try to gently tap the valve or pull out
and look for a small piece of brass or sliver that
is causing it to stick-loosen it up-best w/o
removing it completely and it should work. Caution
if something is on 3 pt it may come down with a
bang. Remove anything that is on the 3 pt. Chuck
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
New Hitches For Your Old Tractor - by Chris Pratt. For this article, we are going to make the irrational and unlikely assumption that you purchased an older tractor that is in tip top shape and needs no immediate repairs other than an oil change and a good bath. To the newcomer planning to restore the machine, this means you have everything you need for the moment (something to sit in the shop and just look at for awhile while you read the books). To the newcomer that wants to get out and use the machine for field work, you may have already hit a major roadblock. That is the dreaded "proprietary hitch". With the exception of the
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
