|
Tractor Talk Discussion Board |
Re: Controlled burn equipment
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by NEsota on April 10, 2006 at 16:19:07 from (64.131.26.95):
In Reply to: Controlled burn equipment posted by NEsota on April 07, 2006 at 18:36:39:
My controlled burns have not been that controlled and have involved the local rural volunteer fire department, station is three miles from my site. The best burn was when they were on the scene before lighting up. Some burns have scared everything out of me and it is not a good feeling. I feel very lucky because the biggest loss so far was a fence post. My intention with the equipment proposed is to lay down two wet lines a rod or two apart around the parameters, following and controlling the fire between the lines. After that is done lighting the remaining area. As stated in one of the responses the important thing then is having ideal weather conditions. We have used an LP torch or drip ignition (gas diesel mix). Drip is the way to go. Thank you for your responses. CAUTION can not be over stated.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Fabricating Sidesheets - by Chris Pratt. The easiest and best first-time project for wanna-be sheet-metal workers like myself is flat or nearly flat metal cut and drilled to be a tractor's sidesheet. A sidesheet is sheetmetal to cover either the engine as in the case of early Oliver's, Massey-Harris' and many crawlers or the wiring and electrical components as in the case of the Massey-Harris Pony, Allis Chalmers' D Series (D-14, D-15, D-12, D-10, D-17, and D-19). The need for fabricating becomes obvious when you go to buy any of these
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|