Tractor Talk Discussion Board |
Re: Ampere Connections
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by John T on April 08, 2006 at 20:19:43 from (66.244.90.5):
In Reply to: Ampere Connections posted by scdietsche on April 08, 2006 at 19:00:31:
Scott, What I refer to as the ammeters SUPPLY terminal has BUT ONE WIRE and thats to the battery/starter often fed from the starter switch or solenoid where the big ungrounded battery cable is attached. I call the ammeters other treminal the LOAD terminal and its what supples loads like lights and ignition etc., often by a wire to the switches BAT input terminal, PLUS it has another wire leading to the BAT terminal on a Voltage Regulator or Cutout Relay or an alternators main output stud. If the ammeter is wired correct polarity, if you turn on lights or ignition tractor not running it should swing over to - discharge and then when running swing over to + discharge if all is working. If it reads bass ackwards, swap its leads. John T
Replies:
Home
| Forums
Today's Featured Article -
Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|