Tractor Talk Discussion Board |
Re: NAA pto
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Gerry_Luzerne_MI on April 06, 2006 at 06:01:38 from (204.38.224.190):
In Reply to: NAA pto posted by Dennis in Texas on April 05, 2006 at 05:29:23:
02: I am surprised that this has not been covered. I have a 53 NAA and one of the first things I did to it was take the 1 1/16 inch six spline shaft off and put the more modern 1 3/16 inch six spline shaft on. This is an easy fix. All the 20-30 years of splines are now 1 3/16 inch diameter. I hope this is what you need. Post back if this does not make sense and I am way off base.... Gerry p.s. you maybe able to get an adapter if you don't want to change out the shaft.
Replies:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|