|
Tractor Talk Discussion Board |
Re: When to change the oil?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by nw_bearcat on March 16, 2006 at 05:14:02 from (164.144.240.25):
In Reply to: When to change the oil? posted by DavidA on March 15, 2006 at 10:16:58:
JD used to sell a 0w-40, or 5w-40 syn. we used it in our feeding tractors-JD4440, jd4430, ford 4000gas, and it really helped them start in the winter, and build oil pressure quicker when very cold. our local dealer quit carrying it, and now is a special order item, and you have to order like 6 cases at a time to get it. now in the ford we found a 5w-20 from motorcraft to run in the winter, we've had trouble with it building oil pressure in good time, even after a new oil pump. regarding the oil changes, we try to change them 2x/year if not getting used alot. Most of our use occurs in the summer w/ haying, so we change them in the fall after that is done, and then after the temps equalize and get out of the rise/fall cycle in the spring, we'll change them again to make sure there is no condensation in it before we put them to hard work in the spring. if i was only going to change them 1x, i'd do it in the spring. we just figure better safe than sorry.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Product Review: JB Weld - by Staff. JB Weld is basically an epoxy glue that does an exceptionally good job of bonding to cast iron and steel along with several other materials. As I mentioned, it is so common that I have yet to buy a tractor that did not have JB Weld used somewhere. It is sometimes used so well you can't tell its there and other times used as a sloppy quick fix. Finding where and how it can be used correctly is key to whether you are using it as an "inelegant hack" or an integral solution to difficult and expens
... [Read Article]
Latest Ad:
WANTED Front grille/nose assembly for Massey Ferguson 1160 (also fits 1180 & 1190). Headlight-mount section. AGCO Grille 3706022M91 (supersedes 3705942M91), cover 3705494M1/M2, holders 3705501M91/3711158M92. New/NOS/good used OK. Jonesboro, AR - will pay shipping. Photo appreciated. Thanks
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|