|
Tractor Talk Discussion Board |
Re: 4010 24/12 volt
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Bob on February 22, 2006 at 14:31:52 from (64.21.249.40):
In Reply to: Re: 4010 24/12 volt posted by souNdguy on February 22, 2006 at 11:37:20:
S.G., No problem with going to a 24-Volt alternator. There are lots of 4020's and 5010's and 5020's with 24-Volt alternators. The problem is, the center of the 24-volt system is grounded to the chassis. For loads like fan motors and lights, you can put 1/2 of the load on each battery. With electronic equipment loads, like planter monitors, etc., the units are polarity-sensitive, and the cases are not always isolated from the power supply wires, so, unless one is very carefull, it is easy to toast these units, either with accidental 24-Volts, or reverse polarity. I believe some of the newer 24-Volt stuff may just have the system gounded at the first negative battery terminal, but a straight 24-Volt system is not without problems, either. I have worked with a lot of the Delco series-parallel switches on semis and industrial equipment, and they are not without problems, either. As I said before, I have no problems with my 24-Volt 4020. It has no cab, and I don't run any accessory loads with it, and I would not gain anything by changing it over to 24-Volts. However, for someone who needs lots of current at 12-Volts, a 12-Volt swap may work out well, if it's done correctly.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
History of the Field Marshall Tractor - by Anthony West. Any restorer who has some knowledge of turn of the century farm machinery, will recognize the name Lanz Bulldog!! This machine was to say the least unusual in its appearance. The huge flywheel and coffee percolator shaped exhaust. Along with square body lines and cylinder head protruding forward of the front axle. Would become the visual differentiation that people would quote to separate the Lanz from other period machines. The Marshall company based at the Briannia Works in Gainsborough
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
