Tractor Talk Discussion Board |
Re: Tilling Gardens
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by VaTom on February 14, 2006 at 19:23:48 from (64.4.122.181):
In Reply to: Re: Tilling Gardens posted by Tpohl on February 14, 2006 at 15:09:46:
I doubt it's relevant unless you live near here, and even then not very. But to answer your question, $45-85/hr, depending on the tractor. $45 buys the smallest one. Which is certainly not a recommendation for you. My financial situation is likely different from yours. I turn down more work every year than I accept. Must not be over-charging. I get very good referrals. The real question is how much do you want/need the work? What we do share in common is that I only buy machinery for my use, then see if anybody wants to pay for it. I also have a reputation of being a good operator. Being polite, I don't argue the point. There are undoubtedly better, but I sell the job.
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|