Tractor Talk Discussion Board |
Re: Lo-Boy 185 hydraulics question
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by K-Mo on March 28, 2006 at 06:43:42 from (65.169.189.2):
In Reply to: Lo-Boy 185 hydraulics question posted by MeAnthony on March 27, 2006 at 15:45:07:
You have enough PSI but not enough pump capacity (Gallons Per Minute, GPM). Think about how fast your 3-Point and mower raise when one cylinder is supplied. On a loader you will have two lift cylinders and at times two more bucket cylinders to supply. I have an I-240 with a loader that I need to install a separate pump on for the loader. Now, when using the tractor pump, beside being very slow, the loader will drift down if I try to raise and tilt at the same time.
Replies:
Home
| Forums
Today's Featured Article -
Memories of an IH Super A When I was ? up to 10, I worked on my Papaw's farm in Greeneville, TN every summer. As I grew older (7), it was the thrill of my day to ride or drive on the tractor. My Papaw had a 1954 IH Super A that he bought to replace a Cub. My Papaw raised "baccer" (tobacco) and corn with the Super A, but the fondest memory was of the sawmill. He owned a small sawmill for sawing "baccer" sticks. The Super A was the powerplant. When I was old enough (7 or 8), I would get up early and be dressed to
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|