Re: m444 skidloader carb questions

Posted by Tom H on January 14, 2006 at 18:55:10 from (205.188.117.14):

In Reply to: m444 skidloader carb questions posted by andrew stegman on December 26, 2005 at 16:12:06:

Hi,

I also have a M 444 and went to my Bobcat dealer and picked up the service manual for nearly the same reason. Anyway it says to adjust the float;

with the carburator casting inverted and the float resting lightly against the needle in its seat, there should be 0.3125 inch (1/4 inch woth styrofoam float) clearance between the bowl cover gasket and the free end of the float (side opposite the needle seat.

good luck,

Tom

ps. you can email me with any other questions. I also have an orifinal M444 operator manual and parts book. the part numbers do not match the current Bobcat numbers but the diagrams are great.

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]