|
Tractor Talk Discussion Board |
Re: trouble on the farm
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Steve Crum on January 14, 2006 at 07:18:56 from (4.156.231.204):
In Reply to: trouble on the farm posted by old fashioned farmer on January 14, 2006 at 06:44:57:
In many ways I can relate. First off there is no such thing as a 'secure job". Anybody is disposable, you need'nt ask how I know this. Second, anybody that is doing anything other than sitting on their hands waiting to die, realizes that some risks need to be taken. Third, you cannot do the job without the tools, and you cannot do the job efficently with junk. Newer more advanced technologies are developed with getting the job done more efficently foremost in the minds of the visionarys who developed them. Fourth, everything has a "service life". As much as we like our old iron, common sense tells us that as much as we repair and scab together a piece, the overall picture is it will only do the job it was designed to do, and certainly not as effectively as when it was new. Back when a perticular mowing machine was made, mowing 40 acres a day was profitable. Today it't a losing proposition or break even at best. (refer to point three.) And fifth, don't expect your father or uncles to change, they get their jollys just being contrary, I spent 40 years learning this. Most are more comfortable b***hing about how somebody screwed them over, or taking potshots at somebody that is succeeding by good old hard work. Most of these guys don't recognize the value of their own work, and how the outcome may have been if they had kept the pressure on. Don't become discouraged, if you can't plow thru that wall, find a way around it. Establish your own identity and persue your own agenda. I started working in this direction years ago. I still hear 'Your so an so's stepson', I like to correct them with "no, so an so was my stepfather".
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Massey Ferguson 35 (and up) Tractor Assembly Notes - by Jack Wetmore. These assembly notes are for Massey Ferguson tractors with a two stage clutch and 6 speed, 8 speed and mutli-power transmissions. I see a lot of discussion forum messages regarding damaged clutches from improper assembly. The objective is to have the engine and transmission slide together safely and easily until the gap between the two halves is less than 1/4", BEFORE tightening any of the bolts holding the two together. Using bolts to draw the two halves together will damage the PTO
... [Read Article]
Latest Ad:
2555 Mahindra Shuttle 4x4 heat,air,diesel,7ft Mahindra heavy duty bushhog 7ft snowblade bucket
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|