Re: Threaded Aluminium

Posted by doogdoog on January 13, 2006 at 14:36:25 from (72.132.200.132):

In Reply to: Threaded Aluminium posted by Ken Biggs on January 13, 2006 at 07:30:30:

Aloha,
If I am reading your post right, it looks like you are referring to the engine block thread?? If there is enough clearance, I would get a threaded rod the same size as the bolt and thread it into the block until it bottoms out. Thread two nuts on the end of the rod and lock it. Try turning it with a wrench until it won"t go anymore and do this with the bracket on. Mark it so it will have enough threads for the two nuts after you cut the rod. Put the two nuts back on the end of the rod and screw it back into the hole and you may use some locktite to keep it tight. Remove one nut and secure the other nut and don"t forget the lock washer. This usually works unless the threaded hole is worn out.

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]